AR 5520 affiche F2

Espace de discussion entre techniciens

Modérateurs : Jo, Konicaman

Répondre
Avatar du membre
armand
BEPC
BEPC
Messages : 118
Enregistré le : jeu. 31 mars 2005 00:00
Localisation : yaounde Cameroun
Contact :

AR 5520 affiche F2

Message par armand »

salut mon Copieur AR 5520 affiche F2 et et j'ai pris une cartouche preté par un ami et c'est la meme chose
Armand NANDA YAKOUA
technicien camerounais
Avatar du membre
christer
BEPC
BEPC
Messages : 160
Enregistré le : sam. 11 févr. 2006 00:00
Localisation : Abidjan

Re: AR 5520 affiche F2

Message par christer »

j'ai eu les même blemes sur 3 sharp ar 5620n qui avaient a peu pres 50.000 copies donc j'ai changer le dev et fait une reinitialisation du dev Sim 25-2
ibou diop
Messages : 2
Enregistré le : lun. 04 août 2014 19:04

Re: AR 5520 affiche F2

Message par ibou diop »

Slt Armand c quoi le sous code du F2 qui s'affiche?
Avatar du membre
christer
BEPC
BEPC
Messages : 160
Enregistré le : sam. 11 févr. 2006 00:00
Localisation : Abidjan

Re: AR 5520 affiche F2

Message par christer »

F2 40 Content ATC sensor abnormality
Detail ATC sensor value abnormality
Cause Connector connection trouble
Toner cartridge installation trouble Sensor breakdown
Check and remedy Connect the connector again.
Install the developing unit again.
Replace the developing unit with a normal one.
F2 64 Content Toner supply abnormality
Detail When toner near end is detected with the toner supply time of 50% or less.
When the toner supply time exceeds 300%.
Cause ATC sensor abnormality
Toner supply abnormality
Check and remedy Replace the toner cartridge.Replace the developing unit.
F2 70
Content •Improper cartridge (Destination error, life cycle error)
•Identific t ion error
•Model error
•Type error
•Destination error
•Data abnormality
•Misc error
Detail •The destination of the machine differs from that of the CRUM.
•The trade mark code of the CRUM differs.
•The company code of the CRUM differs.
•The boot program model code does not coincide with the CRUM model code.
•When the CRUM type is other than genuine/ conversion/production rotation.
•The machine destination differs from the CRUM destination.
Cause CRUM chip defect
Improper toner cartridge.
Check and remedy Replace the toner cartridge.

F2 74
Content CRUM chip communication error
Detail An error occurs during communication between the MCU and the CRUM chip.
The CRUM identification error occurs.
Cause CRUM chip abnormality
Developing unit disconnection
MCU PWB abnormality
Check and remedy
Replace the toner cartridge.
Check installation of the developing unit.
Use SIM16 to cancel.
Replace the MCU PWB.
Répondre

Qui est en ligne

Utilisateurs parcourant ce forum : Ahrefs [Bot], Amazon [Bot], cacou31 et 17 invités