Francotech

Hello everybody,
I am trying to attach Cartadis CM4000(made in France)- Coin machine to iR2800 & NP 7161.After inserting coin(one Dirham)cartadis increments count on its panel but copier panel, copy start key doesn't turn green so can not copy the original.It says insert coins.Anybody know the procedure to connect this coin machine to iR2800 & NP 7161. Your help is appreciated & will make my day.
Can anybody email me also on (panalkar@emirates.net.ae) in english language.
Thank you.

http://www.cartadis.com/index_gb.htm

Copie Monnaie France CARTADIS
1, avenue Louison Bobet
Zone des Marais
94120 Fontenay-Sous-Bois
FRANCE
tel: +33 1 48 77 40 60
fax: +33 1 48 77 36 47

I emailed Cartdis two times unfortunately no reply from them. I expect help from Francotech since it's french & cartadis also
Thanks

salut / hi

have you take the cartadis kit for Canon digital copier?? and connect it in the good slot??

Cartadis machine has got more than 10 wire within that only 6 wirs need to connect. I am trying to connect to iR2800'S DC controller jumper connector.But without 100% success

Thank you very much David-C for giving me Cartadis Address.

I emailed them & got information. For other technicians information to connect iR 2800 to this coin machine you need to have seperate interface cable from them.For NP 7161 directly connect to keycounter of the copier.
Thank you all


Nitin