xerox 490
Posté : sam. 01 nov. 2008 01:12
Bonjour atout jais un problème dune copieur xerox 490 copie blane aide svp merci davance
1. Remove the Cartridges.
2. Check that the proper Print Cartridges are installed for the type of
print required.
3. Clean the Head of the Cartridge with a lint free cloth moistened with
warm water.
4. Install the Cartridges.
5. Clean the Cartridges using the CLEAN HEAD procedure. Press
Menu, 1, 2, Select, V, V, Select. Do this 2 times.
6. Make a test print.
Result: Test print is blank?
No: Go to step 12.
Yes: Continue with Step 7.
7. Replace the defective Cartridge.
8. Make a test print.
Result: Test print is still blank?
No: End of RAP.
Yes: Continue with Step 9.
9. Check the Carriage Ribbon Cables J4, J6 and J7 from the Main PBA for
damage. Reconnect or replace Carriage Assembly as required
REP 4.4 Carriage Assembly.
10. Make a test print.
Result: Test print is still blank?
No: End of RAP.
Yes: Continue with Step 11.
11. Replace REP 4.4 Carriage Assembly. If problem has not
been corrected replace REP 4.5 Main PBA.
12. Perform the Cartridge ARRANGE ALIGNMENT procedure. Press
Menu, 1, 2, Select, V, Select.