Demontage Four sur une HP LaserJet P2015dn

[benjpa]

Bonjour
Comment ce démonte le four sur une HP Laser Jet P2015dn. Car sa fait une journée que je suis dessus et je ne trouve.
Un grand merci d'avance pour voter aide.

[David_C]

A vos marque ... prêt .... partez !

Several parts must be removed before you can remove the fuser itself. The following parts are included in this section about removing the fuser:
● Fan
● Duplex-drive gears/face-down gears
● Duplex solenoid
● Fuser

Fan removal:
1. Remove all covers.
2. Disconnect the fan cable at the ECU.
3. Unthread the fan wires from the retaining clips.
4. Remove two screws.
5. Unhook the fan clip and then lift the fan off the printer.

Duplex-drive gears (HP LaserJet P2015d, P2015dn, and P2015x printers only) removal:
1. Remove all covers.
2. Remove the fan.
3. Remove three screws.
4. Lift the assembly away from the printer.

NOTE: Be very careful at this point, because if you're not, all the gears will fall out and you'll have to figure out how to put them back in correctly or it won't work.

Duplex solenoid (HP LaserJet P2015d, P2015dn, and P2015x printers only) removal:
1. Remove all covers.
2. Remove the fan.
3. Remove the duplex-drive gears.
4. Disconnect one cable at the duplex-drive PCA.
5. Remove one screw, and then lift the solenoid off the printer chassis.

Fuser removal:
1. Remove all covers.
2. Remove the fan.
3. Remove the duplex-drive gears or face-down gears.
4. Remove the formatter.
5. On the right side of the printer, press the tabs on two gears to release the gears, and then
slide the gears off the shafts.
6. Disconnect one cable on the right side of the printer.
7. Disconnect four cables from the ECU, and then disconnect two more cables that were
behind the first set.
8. Pull the tab on the cable holder at the left side of the printer and slide it toward the center to
release it from the frame, and then unroute the cables.
9. Pull the tab on the cable holder and slide it toward the center to release it from the frame,
and then unroute the cables.
10. Remove one screw from the fuser cover, and then slide the fuser cover to the right and
remove it.
11. Disconnect three cables
12. Disconnect one cable, and then unroute the cable from the cable guide.
13. Remove three screws on the right side of the printer.
14. Remove three screws from the left side of the printer.
15. At the left side of the printer, pull the printer chassis from the top to spread the printer frame and
release the fuser from the frame.
16. Pull the fuser out of the printer at an angle so that the delivery roller shaft clears the hole (1) in
the chassis.


Then just reverse the steps above to install the new one.

[benjpa]

Bonjour,

Merci pour ta réponse David_C.